How to Roll Hemp Wraps

How to Roll Hemp Wraps

Hemp wraps are becoming increasingly popular among cannabis consumers as an alternative to traditional tobacco wraps. They offer a unique smoking experience and allow the flavors and aromas of the cannabis to shine through. If you're new to using hemp wraps, here's a guide on how to use them:

Step 1: Choose your hemp wrap

Hemp wraps come in a variety of sizes and flavors, so it's important to choose one that suits your needs. Some popular flavors apart of the KONG line include grape ape, mango tango, and natural hemp. You can also choose between pre-rolled cones or regular wraps, depending on your preference.

Step 2: Grind your cannabis

To roll your cannabis, you'll need to grind it up first. Use a grinder to break the cannabis into small, even pieces. Depending on your preference you can also use your fingers to break down the bud. Often times for blunts/wraps its better to grind the weed into slightly bigger chunks. By doing this it will be easier to roll without a filter as well as make the weed stick together to create a perfect bar. This will ensure that it burns evenly and provides a smooth smoking experience.

Step 3: Prepare your hemp wrap

Kong Wraps were made wide for the user who wants to smoke 3.5 or more. You can rip some of the wrap off if you're working with less herb. KONG wraps rip evenly so all you'll need to do is pick what side you're taking off and just tear it. 

Step 4: Fill the hemp wrap

Place the ground cannabis in the center of the hemp wrap, spreading it out evenly. Be sure not to overfill it, as this can make it difficult to roll.

Step 5: Roll the hemp wrap

Starting at one end, tuck the hemp wrap around the cannabis and begin rolling it tightly. Use your fingers to shape it as you go, making sure that it's tight and even. Lick the  strip at the end of the wrap and seal it shut.

Step 6 : IMPORTANT - DON'T LICK TOO MUCH OR USE A LITTLE BIT OF WATER

Once you have the blunt casted and rolled up you want to go ahead and lick the edge from left to right once. Just like how you would a joint's glue strip. After licking once across your'e going to put your lips to the middle or end and lick between the paper . Using your top lip, lick down on the top layer of wrap and bring it down to stick on the other side. Its easier to start in the middle, work your way to the mouth piece side and then finish the other side. Another way to get this done with licking is to do this same system but instead dip your finger in water and rub it against both sides where the wrap will be sticking. Water can weigh the wrap down and create a perfect seal without feeling like you just deep throated the blunt in spit. This is our recommended way

Step 6: Light up and enjoy!

Once your hemp wrap is rolled, light it up and enjoy the unique flavors and aromas of your cannabis. Be sure to take your time and savor the experience.

Best Tip to light up for an even burn - DONT light the blunt in your mouth, this can create a bad and uneven burn and can soak your weed in lighter fluid. instead hold the blunt and light it with the lighter. You Dont have to light each side for too long but you gotta make sure each side is beginning to burn. Take a couple puffs and blow it back through the top of the blunt. This is a trick pro cigar smokers do to get an even burn. Overall if you look at the blunt top down you'll be able to tell which side isn't burning and you can adjust to this. 

In conclusion, using hemp wraps is a fun and unique way to enjoy your cannabis. By following these simple steps, you can roll your own hemp wrap and enjoy the authentic flavors and aromas of your cannabis. Just remember to use them in moderation and with caution, as smoking anything can have negative effects on your health. SMOKE LIKE A KING

- KONG 

Share Tweet Pin it
Back to blog

Leave a comment

Please note, comments need to be approved before they are published.